Ensure there is propane and that the tank is turned on, ensure battery is charged and connected. Check fuse.
Ensure that the squeegee is clean/undamaged and that the vac hose is not obstructed. Then check how the squeegee is touching the floor it should have a nice even deflection across the whole band. If there is not a nice deflection adjust the squeegee. If streaking still persists trying upping the amount of water you put down, clean your pads and ensure you are removing the most amount of sand and debris from the floor.
Read the label carefully and add water first then chemical.
There is most likely a build up of food based grease that needs be removed from the floor then maintained with a enzyme cleaner daily.
While bleach and pine scope have their place in the cleaning world you should reconsider using them on a finished floor as they destroy the finish which will cause you to have them recoated more often, better option is a ph neutral cleaner.
Battery was not fully charged, one of the cells on the battery is damaged, a major component motor is going out and drawing more amps.
These are the most trafficked areas in your store most likely your finish is worn more coats of finish should be added to these areas on the next re-coat.
High quality finishes do not dust so look at changing your floor finish. Why add an extra step of dusting products when you can just have a better product on your floor!
White pads can be used for daily use on lightly used floors, on heavier trafficked floors we recommend red pads for daily use. For deep cleans we recommend blue or green pads.
For a high shine we recommend a white or luster blue pad, for heavily scratched floors that need repairs we recommend a combo pad or extreme hog hair.
Sunlight reaches Earth’s atmosphere and is scattered in all directions by all the gases and particles in the air. Blue light is scattered more than the other colors because it travels as shorter, smaller waves.
We recommend having your machines inspected quarterly, we have found that this helps prevent unnecessary breakdowns.
Changing the oil is extremely important but equally important is that the air filter is clean along with the valves being adjusted properly ensuring that emissions for interior use are safe!
Ensure there is floor finish down and it is clean! Then running a high speed burnisher on the floor and the shine will return.
Enclosed tanks hold on and grow nasty bacteria which produces some wicked smells! Try rinsing out your tank after every use and treating the tank with a holding tank chemical to make it smell fresh!
Shower regularly and apply deodorant. If smell persists try cologne or seek professional medical help!
Your burnisher is not running cleanly stop using the burnisher and bring it in for an emissions test and tune up.
Yes we sell and buy all types of floor equipment, if you have an exact need let us know and we will give you Unique help!
Most warrantees cover the main components of the equipment. They do not cover consumables or abuse.
High traffic floors should be cleaned daily or multiple times a day, low traffic areas can be cleaned as need or weekly.
This is a loaded question that starts with it depends…. We only sell floor finishes with high quality solids in them so reach out and we can walk you thru what is the best finish/wax for your application.
Yes, we sure do! Create A Free Account and it will save your orders and allow for easy re-orders. You can also check out all our products by clicking the button below.
Yes we offer bulk discounts on most of our products.
Yes we sure do, not all things ship cheaply though strippers and other hazmats incur special fee and have to travel via ground transpiration.
Yes we do, please check out our listings on the Equipment Rental page or contact us today for more information.
Dreams contain memories of past events, thoughts and concerns remixed into novel scenarios. Memories are dynamic and constructive, and remembering the past underlies our capacity to imagine the future.
We accept all major forms of payment(Cash, Check, Money order, Credit card, cash app, Apple Pay), we prefer cash or check as there are less fees associated with these methods.
Color solve allows you to get about 1000 sq ft out of a gallon while acetone will only average you about 500 sq ft.
We recommend using the GPR 00 pad and water
This depends on product availability and if you can pick it up. If the stars align you can pick the item up immediately.
We do not allow returns of opened or used items. Other returns are allowed with a restocking fee.
Yes we would love to help you become better at your craft or learn a new skill. Give us a call at (803) 359-4180 and we can set up a training session. You can also check out our upcoming training events on our training page.
Reach out and we will gladly help you find it!
Excessively aggressive tool marks will likely need to be removed with the same diamonds that caused the tool marks, a mist of water may help. Once a visual check has occurred and an even scratch pattern has been achieved over the entire floor you will be ready to thoroughly clean the floor and move onto the next grit.
Staining a floor is chemically altering the surface with acids or bases which intern changes the color of the floor. Dyeing is taking a color and getting it to penetrate the floor which alters the color.
The MOHS Hardness needs to be at least 5 and you would start the process with densifying with smart floor care system.
Ensure there is propane and that the tank is turned on, ensure battery is charged and connected. Check fuse.
Ensure that the squeegee is clean/undamaged and that the vac hose is not obstructed. Then check how the squeegee is touching the floor it should have a nice even deflection across the whole band. If there is not a nice deflection adjust the squeegee. If streaking still persists trying upping the amount of water you put down, clean your pads and ensure you are removing the most amount of sand and debris from the floor.
Read the label carefully and add water first then chemical.
There is most likely a build up of food based grease that needs be removed from the floor then maintained with a enzyme cleaner daily.
While bleach and pine scope have their place in the cleaning world you should reconsider using them on a finished floor as they destroy the finish which will cause you to have them recoated more often, better option is a ph neutral cleaner.
Battery was not fully charged, one of the cells on the battery is damaged, a major component motor is going out and drawing more amps.
These are the most trafficked areas in your store most likely your finish is worn more coats of finish should be added to these areas on the next re-coat.
High quality finishes do not dust so look at changing your floor finish. Why add an extra step of dusting products when you can just have a better product on your floor!
White pads can be used for daily use on lightly used floors, on heavier trafficked floors we recommend red pads for daily use. For deep cleans we recommend blue or green pads.
For a high shine we recommend a white or luster blue pad, for heavily scratched floors that need repairs we recommend a combo pad or extreme hog hair.
Sunlight reaches Earth’s atmosphere and is scattered in all directions by all the gases and particles in the air. Blue light is scattered more than the other colors because it travels as shorter, smaller waves.
We recommend having your machines inspected quarterly, we have found that this helps prevent unnecessary breakdowns.
Changing the oil is extremely important but equally important is that the air filter is clean along with the valves being adjusted properly ensuring that emissions for interior use are safe!
Ensure there is floor finish down and it is clean! Then running a high speed burnisher on the floor and the shine will return.
Enclosed tanks hold on and grow nasty bacteria which produces some wicked smells! Try rinsing out your tank after every use and treating the tank with a holding tank chemical to make it smell fresh!
Shower regularly and apply deodorant. If smell persists try cologne or seek professional medical help!
Your burnisher is not running cleanly stop using the burnisher and bring it in for an emissions test and tune up.
Yes we sell and buy all types of floor equipment, if you have an exact need let us know and we will give you Unique help!
Most warrantees cover the main components of the equipment. They do not cover consumables or abuse.
High traffic floors should be cleaned daily or multiple times a day, low traffic areas can be cleaned as need or weekly.
This is a loaded question that starts with it depends…. We only sell floor finishes with high quality solids in them so reach out and we can walk you thru what is the best finish/wax for your application.
Yes, we sure do! Create A Free Account and it will save your orders and allow for easy re-orders. You can also check out all our products by clicking the button below.
Yes we offer bulk discounts on most of our products.
Yes we sure do, not all things ship cheaply though strippers and other hazmats incur special fee and have to travel via ground transpiration.
Yes we do, please check out our listings on the Equipment Rental page or contact us today for more information.
Dreams contain memories of past events, thoughts and concerns remixed into novel scenarios. Memories are dynamic and constructive, and remembering the past underlies our capacity to imagine the future.
We accept all major forms of payment(Cash, Check, Money order, Credit card, cash app, Apple Pay), we prefer cash or check as there are less fees associated with these methods.
Color solve allows you to get about 1000 sq ft out of a gallon while acetone will only average you about 500 sq ft.
We recommend using the GPR 00 pad and water
This depends on product availability and if you can pick it up. If the stars align you can pick the item up immediately.
We do not allow returns of opened or used items. Other returns are allowed with a restocking fee.
Reach out and we will gladly help you find it!
Excessively aggressive tool marks will likely need to be removed with the same diamonds that caused the tool marks, a mist of water may help. Once a visual check has occurred and an even scratch pattern has been achieved over the entire floor you will be ready to thoroughly clean the floor and move onto the next grit.
Staining a floor is chemically altering the surface with acids or bases which intern changes the color of the floor. Dyeing is taking a color and getting it to penetrate the floor which alters the color.
The MOHS Hardness needs to be at least 5 and you would start the process with densifying with smart floor care system.
Sunlight reaches Earth’s atmosphere and is scattered in all directions by all the gases and particles in the air. Blue light is scattered more than the other colors because it travels as shorter, smaller waves.
Enclosed tanks hold on and grow nasty bacteria which produces some wicked smells! Try rinsing out your tank after every use and treating the tank with a holding tank chemical to make it smell fresh!
Shower regularly and apply deodorant. If smell persists try cologne or seek professional medical help!
High traffic floors should be cleaned daily or multiple times a day, low traffic areas can be cleaned as need or weekly.
Dreams contain memories of past events, thoughts and concerns remixed into novel scenarios. Memories are dynamic and constructive, and remembering the past underlies our capacity to imagine the future.
Yes we would love to help you become better at your craft or learn a new skill. Give us a call at (803) 359-4180 and we can set up a training session. You can also check out our upcoming training events on our training page.